Engine Oil Level

1503 and 1630 Series Engines -Standardization of the Engine Oil Level Verification Procedure

IFWATERCRAFT IS IN WATER
1. Bring the engine to its normal operating temperature.Usually after 15 minutes of riding time, not idling.
2. Remove the seats.
3. Let engine idle for 30 seconds then stop engine.
4. Wait at least 30 seconds for the oil to settle inthe engine.
5. Pull dipstick out and wipe clean
6. Reinstall dipstick, push in completely.
7. Remove dipstick again and read oil level. Itshould be between the dipstick marks.

 IFWATERCRAFT IS OUT OF THEWATER
1.Ensure the vehicle is level.
2. Install a garden hose on the exhaust system flushing connector.DO NOT open water tap now.

– Never run engine without supplying water to the exhaust system. Severe exhaust system damages could occur.
– To avoid damaging the drive shaft seal, never run engine longer than 2 minutes when the PWC is out of the water.
3. Remove the seats.
4. Start the engine.
5. Open the water tap.
6. Run the COLD engine at idle for 30 seconds.
7. Close water tap.
8. Bring engine RPM to 4000-4500 RPM for 15 seconds.
9. Stop the engine abruptly by pressing the start/stop button or removing the tether cord.
10.Wait at least 30 seconds for the oil to settle in the engine.
11. Remove the dipstick and clean it.
12. Reinstall the dipstick, ensure to push it in completely.
13. Remove dipstick again and read oil level. It should be between the dipstick marks.